ETS-Lindgren's Model 2165 LoProTM Turntable is ideal for today's EMC test applications where height is a concern and installation options may be limited. The turntable can be used with the popular ETS-Lindgren Model 2090 Positioning Controller or separate Hand Control Unit.
With a top almost flush to the ground plane, excavating a pit to bury a power train assembly is not necessary. LoPro can be used at indoor or outdoor sites where traditional turntables are impractical or impossible to install. In chambers, antenna scan height is maximized because space robbing sub floors are not required. The LoPro's minimal height an ABS/PVC construction is virtually RF invisible, so site attenuation characteristics are virtually unchanged. The optional drive shaft can be used for increased RF isolation of the shielded motor if desired.
Signal I/O between the motor base and optional ETS-Lindgren Model 2090 Positioning Controller is fiber optic, eliminating a potential source of RF interference. The turntable includes 10 meter of fiber optic cable. Additional lengths of cable are available. The LoPro is portable for maximum utility. The unit can be easily disassembled within a few minutes. For more permanent installations, mounting holes for anchor bolts are provided on the base. The unit's toothed-belt drive ensures non-slip rotation for greater positioning accuracy.
Physical Specifications
RPM
VOLTAGE
LINE FREQ
AMP
PHASE
2.5
208-230 VAC
50/60 Hz
3A
Single
DIAMETER
NOMINAL HEIGHT
DISTRIBUTED LOAD RATING
TOP CONSTRUCTION
1.2 m 4 ft
5 cm cm 1.96 in
kg1 0 lb
One-piece PVC
1 Distributed Load Rating: applies when load is evenly distributed