ETS-Lindgren's EMCO brand Model 2188 EuroPro¢â Turntable family is ideal for todays EMC test applications where height is a concern and installation options may be limited. All three turntables in this series are metal topped, have variable speed operation, and feature an optional ground plane interface system to simplify installation. They can be operated with popular ETS-Lindgren's EMCO brand Model 2090 Controllers and/or Model 2190 Virtual Controllers. Built to high quality standards, EuroPro turntables have a two year warranty. Features of Model 2188 EuroPro: Low Profile, High Capacity, Three Diameters Designed for indoor use, the EuroPro¢â turntable is perfect for installations in new or existing chambers where pit excavation is not an option or must be shallow. The 1.2 m diameter EuroPro has a 148 mm height and support payloads of up to 500 kg. The 1.5 and 2 m diameter EuroPro¢âs also have a height of 148 mm and support payloads of up to 1,000 kg. Variable Speed EMC measurement throughput can be improved using the EuroPro¢âs variable speed drive. Higher RPM's can be used to obtain a quick overview of emission problems or return to a desired position. Lower RPM's can be used to scan apertures of particular interest. Fiber Optic Control Lines Signal I/O between the motor base and ETS-Lindgren's EMCO brand controllers are fiber optic, eliminating a potential source of RF interference. The turntable includes 10 meters of fiber optic cable.
ETS-Lindgren's Model 2188 EuroPro¢â turntable family is ideal for today's EMC test applications where height is a concern and installation options may be limited. All three turntables in this series are metal topped and have variable speed operation. They can be operated with ETS-Lindgren's Model 2090 Positioning Controller. Built to high quality standards, the EuroPro¢â has a two year warranty.
EMC measurement throughput can be improved using the EuroPro's variable speed drive. Higher RPM's can be used to obtain a quick overview of emission problems or return to a desired position. Lower RPMs can be used to scan apertures of particular interest. Existing ETS-Lindgren Positioning Controllers can be used with the EuroPro, however, the Model 2090 must have firmware revision 3.11 or higher.
Standard Configuration
Ground brush and floor flange
Turntable assembly
10 m fiber optic cable
Electrical Specifications
RPM
VOLTAGE
LINE FREQ
AMP
PHASE
.5 - 2.0
230 VAC
50/60
3.0
1
Physical Specifications
DIAMETER
NOMINAL HEIGHT
DISTRIBUTED LOAD RATING
TOP CONSTRUCTION
1.5 m 4.92 ft
14.8 cm cm 5.8 in in
1000 kg1 2200 lb
One-piece metal
1 Distributed Load Rating: applies when load is evenly distributed on top; no point loads under .19 sq m (2 sq ft) should exceed 100 kg (220 lb); and not over 28.5 kg (63 lbs) should be applied to a 45¢ª segment at the table outer edge.